Honeywell 5821 Installation Instructions And Owner's Manual page 2

LifeShield Supported Operating
Modes & Settings
Install The Sensor
1. Locate the Honeywell 5821 (red and white)
box and remove the white wireless
transmitter from the box.
2. Using a flat object such as a screwdriver,
pry off the top cover of the transmitter and
set it aside.
3. Press down on the mounting plate bracket
release tab to remove (slide off) the mount-
ing plate. Place the mounting plate aside.
4. Reference Table 1 to determine the desired
sensing type (Hot Temp, Cold Temp, Warm
Temp or Flood [water]). Using the tip of a
paperclip (or similar object) push the white
(sliding) buttons of the DIP switch (see
Figure A) into the configuration that
corresponds to the desired sensing type.
5. Follow the appropriate steps associated
with the sensing type of the Sensor.
a. Temperature Sensor (Hot, Warm or
Cold) sensing: Locate the mounting
bracket where it will be most suitable for
Temperature Sensing (for example on a
wall, ceiling, etc.). Using either the
supplied screws or double-faced
adhesive tape, secure the mounting
bracket to a flat surface (wall or ceiling).
b. Flood (water) sensing:
i. Locate the water probe assembly (with
wires attached as shown) and mount it
near the "baseline" surface (ex. floor)
using the supplied double-faced tape
or suitable wall mounting screws (not
supplied). It is recommended that the
probe be mounted between 0 to 1/8"
above the baseline surface.
ii. Loop the free end of the Water
Probe wire through the back of the
wireless transmitter (as shown in
Figure A) and connect the wire pair to
the loop terminal block by inserting
the wires (individually) into the loop
terminals and tightening the screws.
iii. Determine the best location to install
the mounting plate above the loca-
tion where the Water Probe has
been installed, being careful not to
position it too high (beyond the length
of the wires now connecting the
water probe and wireless
transmitter).
iv. Using either the supplied screws or
double-faced adhesive tape, secure
the mounting bracket to a flat surface
(wall or ceiling).
6. Install the CR123 battery (supplied) into the
wireless transmitter noting the correct
orientation of the positive (+) and negative
(-) ends.
7. Position the wireless transmitter over the
mounting plate and slide the wireless
transmitter securely into place (until it
"clicks").
Note: Do not re-attach
Battery
cover until you have
added this device to the
LifeShield System
Add the Sensor to the LifeShield
System
Once the Temperature and Flood (Water)
Sensor is installed it must be "added" to the
LifeShield system in order to function. You will
need a Handset (or Console) to add it.
Enter the Security menu on
the Handset (or Console)
1. On the Handset
(or Console),
Press MENU.
2. Scroll to Security Setup,
press SELECT and enter
the Master Code.
3. Scroll to Sensors, press
SELECT.
4. Scroll to <Add New>,
press SELECT.
5. Scroll to Environmental,
press SELECT.
6. Following the instruc-
tions displayed on the
Handset (or Console),
wait 5 seconds, then
press and release the
red tamper switch button
on the wireless
transmitter (see
Figure A).