Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. SPECIFICATIONS Model: DFJ210 / DFJ310 / DFJ410 / DFJ212 / DFJ211 DFJ311...
Save all warnings and instruc- Symbols tions for future reference. Some of the following symbols are used for the product. Never use the fan jacket when temperature Be sure to understand their meaning before use. reach more than 50°C (122°F). Also avoid use in high humidity.
Charging improperly or at temperatures also void the Makita warranty for the Makita tool and outside the specified range may damage the charger. battery and increase the risk of fire. Tips for maintaining maximum...
Power cable (10.8 V - 12 V max) (14.4 V /18 V) (optional accessory) (optional accessory) Model DFJ210 / DFJ211 / DFJ310 / DFJ311 / DFJ410 / DFJ411 Loop for name badge Loop for arm badge Sleeve holder Battery pocket...
Attaching the battery holder INSTALLATION You can hang the battery holder on your waist belt. Installing or removing the battery To prevent the battery holder from dropping acciden- tally, attach a strap using the strap hole and secure it. cartridge 18 V / 14.4 V 10.8 V CAUTION:...
Page 8
Connect the power cable to the fan units. Support the cable using the cable holder. For model DFJ210 / DFJ211 / DFJ310 / DFJ311 / DFJ410 / DFJ411 ► 1 . Fan unit 2. Ring 3. Hook 4. Slot 5. Mark Pass the head of the fan unit into the hole on the jacket. Set the ring onto the fan unit and turn it clock-...
Connect the other end of the power cable to the When tightening the ring, stop it at the mark near the battery holder. slot on the fan unit. After attaching the fan units, cover the filter attachments with filters. ► 1 . Battery holder ► 1 .
Press the check button on the battery cartridge to indi- cate the remaining battery capacity. The indicator lamps Air flow light up for a few seconds. For DFJ210 / DFJ211 / DFJ310 / DFJ311 / DFJ410 / DFJ411 only Indicator lamps Remaining capacity To maintain a stable air flow, close the button at the neck of the jacket. Fasten the button on the ribbon for better air flow in the back.
► 1 . Cover 2. Switch (For DFJ210 / DFJ211 / DFJ310 / DFJ311 / DFJ410 / DFJ411 only) The USB cable can be placed inside the jacket for Mesh pocket convenience using the hole in the pocket and the cable holder.
CAUTION: before attempting to perform inspections or These accessories or attachments maintenance. are recommended for use with your Makita tool specified in this manual. The use of any other CAUTION: If the jacket does not switch on accessories or attachments might present a risk of or any fault is found with a fully charged battery injury to persons. Only use accessory or attachment...