Installing/Removing Power Modules - Siemens RUGGEDCOM RX1501 Installation Manual

Hide thumbs Also See for RUGGEDCOM RX1501:
Table of Contents

Advertisement

RUGGEDCOM RX1501
Installation Guide
1
2
3
Figure 16: Installing a Module
1. Module    2. Chassis    3. Screw
5.
Tighten the screws to secure the module.
6.
[Optional] If necessary, install the device in the rack.
7.
Connect power to the device.
Section 3.3

Installing/Removing Power Modules

The RUGGEDCOM RX1501 supports a single power module.
Figure 17:  Power Module
1. Power Module
CAUTION!
Contamination hazard – risk of equipment damage. Prevent the ingress of water, dirts and other debris
that may lead to premature equipment failure. Always make sure slots are not left empty.
Removing a Power Module
To remove a power module, do the following:
1.
Loosen the screws that secure the module to the chassis until the module can be removed.
2.
Slide the module out of the chassis.
Installing/Removing Power Modules
1
Chapter 3
Modules
27

Advertisement

Table of Contents
loading

Table of Contents