Configuring The Device - Siemens RUGGEDCOM RX1501 Installation Manual

Hide thumbs Also See for RUGGEDCOM RX1501:
Table of Contents

Advertisement

Chapter 2
Installing the Device
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch and access the ROX II console
and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM RX1501 is
https://192.168.0.2
For more information about available ports, refer to
Section 2.8

Configuring the Device

Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROX II interface. For more information about configuring the device, refer to the
RUGGEDCOM ROX II User Guide associated with the installed software release.
16
.
Pin
7
8
Chapter 3, Modules
.
Installation Guide
Name
Description
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Configuring the Device
RUGGEDCOM RX1501

Advertisement

Table of Contents
loading

Table of Contents