If Paint Is Used; Plastic Mold Tooling; Plastics Flammability; Texture/Glossing Of Housing - Philips 160E1SB/93 Service Manual

If paint is used

RoHS required
WEEE require
If new painting type needs to implement, refer to UN-D 1235.

Plastic mold tooling

Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.

Plastics flammability

All Plastics to be Flame Retardant UL 94-HB.
Base / Rear to be Flame Retardant UL 94-HB
All major plastic parts (bezel, back cover) need to be molded from same resin
Plastic resin type selection should be referred to "plastic-Philips Pool monitor"

Texture/Glossing of housing

The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
> = 80 gloss units

Tilt and swivel base

Tilt angle : -5 +2/- 0 (forward)
+20 +0/- 2 (backward)
Tilt for left and right:
A-B
Black side and cut side
L
Gap between bezel and rear cover
Step between bezel and rear cover
"Wobble", "Twist", etc (front to back or side to side)
Whole monitor set shall retain stability within a short time after the applied external force disappears.
20NT , 6secs Max. back to stable.
3.0MM
U
D
0.2 mm (Typ.) Max. will wait for 1
Left, right and top: 0.3mm
A
1. Visual area
H
V U-D
R
2. Black side on the left and right is
symmetrical, not cut side.
st
lot of MP to correct the data.
Bottom and corner: 0.5mm
Meridian 1
B
L-R 0.8~1.0mm
0.8~1.0mm
79