Advertisement
Installing the Cisco Input Module
Connect the module to the DC power source:
Step 2
Insert a two-pin connector plug into the DC power port
a.
Connect the Voltage In (VIN) and ground (GND) wires.
b.
See
Power Options and Requirements, page 1-10
Figure 4-5
The following items are shown in
Configuration
1
DC power
GND (ground)
2
DC power
Voltage In (VIN)
Step 3
Connect the module to the CAN bus:
a.
Insert a three-pin connector plug into the CAN1 port, as shown in
b.
Connect the CAN wires to the CAN bus, as shown in
c.
Turn the CAN terminator ON if the device is the last device in a CAN wiring bus.
The CAN terminator switch in included on the Reader, Input and Output modules only (the Gateway is
Note
always the first device in the CAN bus). Set the terminator switch to OFF for all other modules in the
CAN bus.
Note
The CAN2 interface is not supported in this release.
See
Optional Expansion Modules, page 1-6
Cisco Physical Access Gateway User Guide
4-6
Power Connections for the Input and Output Modules
Figure
4-5:
Description
Connects the DC ground wire to the module.
Connects the DC Voltage In (VIN) wire to the module.
Chapter 4
(Figure
4-5)
for more information.
1
2
Figure 4-7
for more information.
Connecting a Cisco Input Module
Figure
4-6.
OL-20932-01
Advertisement
