Hitachi SuperDrive 75 Series Operating Instructions

HITACHI SuperDrive Auto-feed Screw System
WARRANTY
HITACHI SuperDrive tools and system components are warranted to the original retail purchaser to be free from defects in
material and workmanship One year from the date of purchase. A dated sales receipt or proof of purchase is required to
make a warranty claim.
The warranty shall only cover defects in material or workmanship. The warranty shall not cover normal wear items or issues
arising from improper use, as determined by HITACHI Koki USA, Ltd. in its absolute discretion.
HITACHI Koki USA, Ltd. is not responsibility for malfunctions, failures or defects resulting from misuse, abuse, neglect,
alteration, or modification of the HITACHI SuperDrive tool and system components. HITACHI Koki USA, Ltd. disclaims any
warranty regarding fitness for any particular use or application of its tools or fasteners. No other warranties, representations
or promises as to the quality or performance of the HITACHI SuperDrive fastening tool and system components are made,
other than those contained herein.
ANY IMPLIED WARRANTY GRANTED UNDER STATE LAW, INCLUDING WARRANTIES OR MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE, ARE LIMITED TO DURATION OF THE EXPRESS WARRANTY GRANTED HEREIN. HITACHI KOKI USA,
LTD. SHALL NOT BE LIABLE FOR DIRECT, INDIRECT, INCIDENTAL, PUNITIVE, OR CONSEQUENTIAL DAMAGES. SOME STATES
DO NOT ALLOW FOR EXCLUSIONS OR LIMITATIONS OF DAMAGES SO THE ABOVE LIMITATIONS MAY NOT APPLY.
®
TM
TM
TM
TM
®
TM
SAFETY NOTES:
1. Make sure the SuperDrive 75 tool is powered down and
unplugged before replacing a bit, or removing the indexing unit.
2. Never use SuperDrive 75 while standing on an unstable platform.
3. Never point the driver at yourself or others in the work area.
4. Avoid wearing loose clothing, jewelry or other items that could
become caught in the tool.
5. Make sure SuperDrive 75 is clear of clothing, hair or other loose
items while operating the tool.
6. Make sure the tool is powered down and unplugged before
performing any adjustment or repair to the indexing module.
7. Always use collated screws and strips that are designed for this tool.
See Technical Data below.
Operating Instructions for SuperDrive
1. Remove factory nose piece
3. Attach SuperDrive 75 coupler
OPERATING SuperDrive 75
Attaching the indexing Module
1. Remove the factory nose piece and bit from
the driver.
2. Remove the bit holder from the driver.
(A)
3. Attach SuperDrive 75 coupler to the Hitachi
4. Insert SuperDrive bit tip into the screw gun
driver. (A,B)
4. Insert SuperDrive bit tip into the screw gun.
(A,B)
(A)
®
TM
TECHNICAL DATA:
1. Use SuperDrive 75 with #6-#12 gauge screws only.
2. Use SuperDrive 75 with screw lengths from 5/8-in (16mm) - 3-in
TM
(76mm) only.
3. SuperDrive 75 is designed for fastener head diameters up to
3/8-in.
TM
4. Only use bits with a 6mm shank diameter with SuperDrive 75.
5. SuperDrive 75 is designed to work best with the following bits:
725449 - 178mm Square
725438 - 178mm Phillips
725439 - 178mm LOX
75
®
2. Remove bit holder and bit
(B)
(B)