Fascia Installation (Antumbratouch) - Philips Antumbra Installation Manual

2.2.5

Fascia Installation (AntumbraTouch)

The rim and glass fascia for the AntumbraTouch panel are supplied as a single piece.
Ensure that the air vent on the rim, shown below, is placed over the temperature sensor on
the application module. Place the glass face on the application base and gently press it to fix
the panel to the base.
To remove the glass face from the application base, loosen the glass face from the bottom
and then the sides and later lift it from the application base. The pictures below show the
correct way of removing the glass face from the application base.
Antumbra 23
13 October, 2017
Ordering Antumbra Panels