Epson RC180 Manual page 95

LED Description of DeviceNet
LED status represents the status of the fieldbus board.
GRN
RED
Board Installation of DeviceNet
Set the baud rates between the MAC address of the device and the master by setting the
DeviceNet board configure switch.
(1) Set the MAC address for DeviceNet board by setting the configure switch. Make
(2) Set the DeviceNet baud rate. Check the master configuration and set the same baud
RC180 Rev.17
LED status
Communication power supply OFF
OFF
Disconnected
Link OK
ON
Online connected
Blinking Online disconnected
ON Link error
Blinking Communication time out
sure that the MAC address is different from the other devices in the network. Refer
to the following table for the configuration.
MAC address
0
1
2
3
. .
.
62
63
(at shipment)
rate. Refer to the following table for configuration settings.
Baud Rate
125 K
250 K
500 K
Configuration prohibited
Setup & Operation 12. Option Units
NS
sw3
sw4 sw5
(MSB)
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
ON ON ON
ON ON ON
Switch
sw1 sw2
OFF OFF
OFF ON
ON OFF
ON ON
MS
Device power supply OFF
Device operating
Data size error
Critical error
Error
Switch
sw6 sw7
OFF OFF
OFF OFF
OFF ON
OFF ON
OFF OFF
ON ON
ON ON
sw8
(LSB)
OFF
ON
OFF
ON
OFF
OFF
ON
83