Breville Smart Oven BOV670 Instruction Book page 38

Troubleshooting
PROBLEM
The temperature reading
on the LCD screen doesn't
match the temperature
measured inside the oven.
The 'preheat' alert sounds
at a lower temperature
than what is displayed
on the LCD screen.
The LCD screen
displays 'E01'
The LCD screen
Displays 'E02'
The LCD screen
Displays 'E03'
The LCD screen
Displays 'E04'
The LCD screen
Displays 'E05'
38
EASY SOLUTION
•
To ensure the measurements are standardized, the oven temperatures
have been calibrated in the TOAST position (center of the middle
rack with no tray in place). Re-check the temperature in this position,
ensuring not to open the oven door for 10 minutes as heat will escape
each time the door is opened. Note that the 'preheat' alert sounds at 75%
of the target temperature. See below for full explanation.
•
The 'preheat' alert sounds at 75% of the target temperature. This
provides the fastest, combined preheating and cooking time. This
is because when the 'preheating' alert sounds, signaling the user to
open the oven door and insert food, there is dramatic temperature loss
inside the oven. If the alert sounded at 100% of the target temperature,
opening the door would mean a lot of this waiting time is "wasted".
We have calculated that by sounding the alert at 75% of the target
temperature, followed by the oven door being opened to place food
inside the oven, that we still recover to the target temperature up to 2
minutes faster. This is why the temperature on the LCD screen does
not match the target temperature at the 'preheat' alert. In total, it takes
the oven approximately 8-10 minutes from start-up, including opening
the oven door when the 'preheat' alert sounds, to reach the target
temperature. To ensure the fastest heat up time, the Breville oven uses
the maximum allowable power from the outlet (1500W for baking,
1800W for toasting).
•
The LCD screen will display 'E01' when there is a non-resettable issue
with the appliance. Should this occur, immediately remove the power
cord from the wall outlet and call the Breville Consumer Support
(1-866-BREVILLE).
•
The LCD screen will display 'E02' when there is a non-resettable issue
with the appliance. Should this occur, immediately remove the power
cord from the wall outlet and call the Breville Consumer Support
(1-866-BREVILLE).
•
The LCD screen will display 'E03' if the oven temperature is above the
set maximum limit. Remove the plug from the wall outlet, allow the oven
to cool for 15 minutes, then plug back in.
•
Call Breville Consumer Support (1-866-BREVILLE) if the 'E03' message
continues.
•
The LCD screen will display 'E04' if the room temperature is below the
set minimum. Unplug the oven and relocate to to a warmer area.
•
The LCD screen will display 'E05' when there is a non-resettable issue
with the appliance. Should this occur, immediately remove the power
cord from the wall outlet and call the Breville Consumer Support
(1-866-BREVILLE).