Honeywell T6 Pro Z-Wave Professional Install Manual page 2

Introduction
The Honeywell T6 Pro Z-Wave Programmable Thermostat is a Z-Wave Plus certi-
fied thermostat capable of controlling up to three heat and two cool stages of heat
pump, (incl. dual fuel heat pump systems) and up to two heat and two cool stages of
conventional system (3H/2C HP, 2H/2C Conv.) It also measures, displays and
reports % indoor relative humidity; however, this model does not control humidifica-
tion equipment.
It is one of the easiest smart thermostats to install and is controllable by all Z-Wave
compliant controllers that have the control capability for "Thermostat" devices.
When integrated with the app that controls your Z-Wave controller, it lets you pro-
gram and control your home's HVAC system as well as controlling other Z-Wave
devices connected to the same Z-Wave controller.
Because the thermostat is battery-powered, low-voltage integrators
can easily connect the thermostat to most HVAC systems. Optional
24 VAC powering via "C" or common wire is also available, if desired.
CAUTION
• We strongly recommend that installation is performed by a trained HVAC
technician.
• Read the enclosed instructions carefully before installing the new
Honeywell T6 Pro Z-Wave Programmable Thermostat.
• ELECTRICAL HAZARD: Can cause electrical shock or equipment damage.
Disconnect power before beginning installation.
• To prevent abnormal operation, it is highly recommended to configure
the installer setup and set the thermostat to correct HVAC system before
including the thermostat to Z-Wave network. If the configuration must
be changed, first EXCLUDE the thermostat from the network, change
the thermostat configuration, and INCLUDE the thermostat back to the
network.
• Before disconnecting wires from the existing thermostat, label the wires
with the terminal markings from the old thermostat and record them. Take
a picture of the old wiring.
• Use 3 new AA batteries in the thermostat.
2