Opening The Access Cover - Cisco AIR-MP20B User Manual

Opening the Access Cover

Follow these steps to open the 2.4-GHz radio access cover:
1. Position the access point so that its bottom cover is facing up.
2. Use a T-10 tamper-resistant Torx L-wrench to remove the access cover
retaining fastener. See the illustration below.
1
Access cover screw
If your access point was not configured with a 2.4-GHz radio, go to the next
section. If you are replacing an existing 2.4-GHz radio, go to the
a 2.4-GHz Radio" section on page
16
1
20.
"Removing