Cisco ASA 5585-X Maintenance Manual page 8

Installing and Removing Cisco ASA 5585-X Network I/O Modules
Table 4-1
1G SFP Module
SFP-H10GB-CU1M
SFP-H10GB-CU3M
SFP-H10GB-CU5M
These SFP+ modules require ASA 8.2.5 or later: SFP-10G-LRM, SFP-10G-LR, SFP-H10GB-CU1M,
Note
SFP-H10GB-CU3M, and SFP-H10GB-CU5M.
Only SFP/SFP+ transceiver modules certified by Cisco are supported on the ASA 5585-X.
Note
Protect your SFP/SFP+ transceivers by inserting clean dust plugs into the SFP/SFP+ modules after
Caution
extracting cables from them. Be sure to clean the surfaces of the fiber-optic cables before you plug
them back into the optical bores of another SFP/SFP+ module. Avoid getting dust and other
contaminants into the optical bores of your SFP/SFP+ modules. The cables do not operate correctly
when obstructed with dust.
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70
To install a 4-, 8-, or 20-port network I/O module and related SFP/SFP+ transceivers into the
ASA 5585-X:
Power off the security appliance.
Step 1
Network I/O modules are not hot-swappable.
Caution
Locate a grounding strap, and fasten it to your wrist so that it contacts bare skin. Attach the other end to
Step 2
the chassis.
Loosen the captive screws on the upper left and right of the top slot tray (slot 1), and remove it
Step 3
(Figure
You must install slot covers on all empty slots to maintain the proper air flow. This also prevents EMI,
Caution
which can disrupt other equipment.
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
4-8
SFP/SFP+ Transceiver Modules (continued)
4-5). Store it in a safe place for future use.
10GBASE-CU SFP+ cable 1 meter, passive
10GBASE-CU SFP+ cable 3 meter, passive
10GBASE-CU SFP+ cable 5 meter, passive
Chapter 4 Maintenance and Upgrade Procedures
OL-22567-02