Searching For A Control Channel; Voice Calls; Making A Voice Call - Kenwood TK-285 Instruction Manual And User Handbook

Searching for a Control Channel

After switching the power ON, press any key while the
power on text or unit number is displayed to begin
searching for a control channel. Or, wait for
2 seconds to allow the transceiver to start searching for
a control channel automatically.
• The indicator flashes and an arrow scrolls across the
SVC
display while the transceiver is searching for a control
channel.

Voice Calls

Making a Voice Call

1 Select a call address using one of the following
four methods:
i) Select a call address from memory: Select
your desired call address using the Rotary
encoder if a call address has been stored in
the transceiver memory.
ii) Use a pre-programmed key: Press key A, B,
C, or D to select a call address if they have
been pre-programmed with call addresses.
iii) Select a call address from the stack: Use a
received voice call from the stack as a call
address (refer to "Viewing the Stack", on
page 14).
iv) Enter a call address using the keypad: Enter
your desired call address using the DTMF
keypad (keys 0 ~ 9, , and #). Refer to the
appendix {page 20} for the available dial
strings and control codes.
9