Functional Description; To Remove Battery Pack - Black & Decker CM2060 Instruction Manual

FUNCTIONAL DESCRIPTION

1. Switch box
2. Bail handle
3. Upper-handle
4. Lower-handle
5. Upper-handle attachments (2)
6. Lower-handle attachments (2)
7. Cut height adjust lever
8. Grass collection bag
9. Rear door cover
10. Dashboard
11. POWERSWAP
12. Battery port
13. Upper carrying handle
14. Lower carrying handle
11
10
battery. See chart in figure A.
• If LED light does not illuminate, charge
battery.
NOTE:
This battery is designed to not
operate when a charge below 20% of
its capacity is reached. After the battery
charge is depleted, the tool will not operate
until after the battery has been recharged.
A
TM
13
A1
A1
5
6
14
12
INSTALLING AND REMOVING
THE BATTERY PACKS
WARNING:
SAFETY KEY IS REMOVED TO PREVENT
ACTUATION BEFORE REMOVING OR
INSTALLING BATTERY.
TO INSTALL BATTERY PACKS:
• Lift and hold the battery port cover (12)
up to expose the battery port (15).
• Slide the battery (16) into the battery
port until it is fully seated and an audible
click is heard (figure B). Make sure
battery pack is fully seated and fully
latched into position. Repeat process
for the second battery port.
• Close the battery port cover. Ensure the
cover is fully latched before starting mower.

TO REMOVE BATTERY PACK:

• Open the battery port cover (12) as
described above.
• Depress the battery release button (17)
on the battery pack and pull battery
pack out of tool as shown in figure C.
9
1
8
9
6
7
MAKE CERTAIN THE
2
3
5
4