VPLS Configuration over MPLS-TP
Note
This chapter is not applicable on the Cisco ASR 900 RSP3 Module.
This chapter describes how to configure VPLS over MPLS-TP on the Cisco ASR 903 Series Router. This
chapter includes the following section:
For more information, see the
•
•
•
•
•
VPLS over MPLS-TP
The sections below provide an overview of VPLS over MPLS-TP:
Multiprotocol Label Switching Overview
The Multiprotocol Label Switching (MPLS) Transport Profile (TP) enables you to create tunnels that provide
the transport network service layer over which IP and MPLS traffic traverse. MPLS-TP tunnels enable a
transition from Synchronous Optical Networking (SONET) and Synchronous Digital Hierarchy (SDH)
time-division multiplexing (TDM) technologies to packet switching to support services with high bandwidth
requirements, such as video.
MPLS Transport
VPLS over MPLS-TP, page 107
Configuring VPLS over MPLS-TP, page 108
Verifying the Configuration, page 121
Configuration Examples, page 122
Feature Information for VPLS Configuration over MPLS-TP, page 123
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
C H A P T E R
Profile.
6
107