Installation Of Pm603/Pm604 On Mvme160X - Motorola RAM104 User Manual

Installation of PM603/PM604 on MVME160 x
To install a PM603 or PM604 mezzanine on an MVME160x module, refer
to Figure 1-3 and perform the following steps:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove the chassis or system cover(s) as necessary to gain access
into the VMEmodule.
Inserting or removing modules with power applied may
!
result in damage to module components.
Caution
Dangerous voltages, capable of causing death, are present
!
in this equipment. Use extreme caution when handling,
Warning
testing, and adjusting.
3. Carefully remove the MVME160x from its VMEbus card slot and
place it on a clean and adequately protected working surface
(preferably an ESD mat) with connectors P1 and P2 (opposite edge
of the module from the front panel) facing you.
Avoid touching areas of integrated circuitry; static
!
discharge can damage the circuits.
Caution
4. Place the PM603 or PM604 mezzanine module on top of the
MVME160x, with the cutout corner at the upper right. Connector J5
at the bottom edge of the PM603 or PM604 should connect
smoothly with its corresponding connector on the MVME160x.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installation
1
1-13