Table of Contents
Advertisement
Electrical Requirements - Whirlpool Cabrio W10164752A Use & Care Manual [Page 6]
*Most installations require a minimum 5" (127 mm) clearance
behind the dryer for the exhaust vent with elbow. See "Venting
Requirements."
Installation spacing for recessed area or closet installation
The following spacing dimensions are recommended for this dryer.
This dryer has been tested for spacing of 0" (0 mm) clearance on the
sides and rear. Recommended spacing should be considered for the
following reasons:
Additional spacing should be considered for ease of installation
and servicing.
Additional clearances might be required for wall, door, and floor
moldings.
Additional spacing should be considered on all sides of the dryer
to reduce noise transfer.
For closet installation, with a door, minimum ventilation openings
in the top and bottom of the door are required. Louvered doors
with equivalent ventilation openings are acceptable.
Companion appliance spacing should also be considered.
6
Next page
Previous page
Dryer Whirlpool WGD6600W Dimensions And Installation Information
Gas dryer (1 page)
Dryer Whirlpool WGD6200S Product Dimensions
Gas dryer (1 page)
Dryer Whirlpool Cabrio W10164159A Use & Care Manual
Steam fabric care system electric dryer (56 pages)
//static-data2.manualslib.com/manual/190510/Whirlpool-Cabrio-W10164752a.html?page=6 (3 of 7)3/20/2018 3:41:43 AM
1 2 3 4 5
6
7 8 9 10
Related Manuals for Whirlpool Cabrio W10164752A
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
120 Volt, 60 Hz., AC only, 15- or 20-amp fused electrical supply
is required. A time-delay fuse or circuit breaker is recommended.
Table of Contents
Advertisement
Advertisement
Table of Contents
