Makita BO6050 Instruction Manual page 7

Installing side grip
1. Side grip
Screw the side grip on the tool securely.
The side grip can be installed on either side of the tool.
CAUTION:
Always use hook-and-loop system
1. Abrasive disc
To install the abrasive disc or the hook-and-loop type
eign matter from the pad.
Then attach the abrasive disc to the pad, using the
hook-and-loop system of the abrasive disc and the pad.
Be careful to align the holes in the abrasive disc with
those in the pad.
edge.
Changing pad
CAUTION:
Make sure the new pad is installed
securely. Otherwise the pad may come off from the
1
1
-
2
1. Random orbit with forced rotation mode 2. Shaft
lock button 3. Pad
Makita offers an extensive range of optional super soft,
soft and hard pads.
1. Use the change knob and change the mode into
random orbit with forced rotation mode.
2. Press and hold the shaft lock button, and remove
the pad by turning the pad counterclockwise.
3. Keep holding the shaft lock button, and install a
Dust nozzle
CAUTION:
Make sure the bolt is securely
tightened after installing the dust nozzle.
Otherwise the dust nozzle may fall and cause per-
NOTICE:
Do not carry the tool by the dust noz-
zle. Otherwise the tool may be damaged.
You can remove the dust nozzle in accordance with the
operation.
To remove the dust nozzle, loosen the bolt, slightly open
the holder part, and remove the dust nozzle.
To install the dust nozzle, insert the mouth of the dust
nozzle into the dust outlet of the housing, align the
tongue of the holder part with the groove of the housing,
and tighten the bolt.
2
3
1. Dust nozzle 2. Dust outlet 3. Mouth
7 ENGLISH
3
1
1