Advertisement
Ceiling and Wall Installation Kit
Drop Ceiling Installation
If you are mounting the base station on a hard ceiling
1
2
instead of a ceiling bar that is typical for a drop ceiling,
use the wall installation instructions.
1. Slide the T-bar partially into the metal bracket
3
4
and attach the metal bracket to the ceiling bar.
7
Then push the T-bar over the ceiling bar and use the
6
8
5
lock screw to lock the metal bracket into place.
2. Making sure that the two protruding
hooks on the plastic bracket are facing
•
Plastic bracket for either drop ceiling mounting or wall mounting. (1)
down, place the plastic bracket against
•
Metal bracket for drop ceiling mounting. (2)
the metal bracket and align the four inner
•
One metal T-bar for drop ceiling mounting. (3)
holes of the plastic bracket with the four
•
One lock screw to lock the T-bar for drop ceiling mounting. (4)
holes of the metal bracket.
•
Four short screws to attach the metal bracket for drop ceiling mounting. (5)
Then insert the four short screws and secure
•
Four tall screws to attach the plastic bracket for wall mounting. (6)
the plastic bracket onto the metal bracket.
•
Four anchors for the tall screws for wall mounting. (7)
•
Four rubber feet for desk installation. (8)
BETA DOCUMENT
May 2017
3. Hold the base station upside down, with
1
the bottom facing the plastic bracket that
3
is attached to the metal bracket, and align
the two rectangular holes in the bottom of
the access point with the protruding hooks
on the plastic bracket.
4. Push the hooks into the holes and turn the
access point to secure it onto the plastic
bracket.
4
2
Result
Wall Installation
5. Push the hooks into the holes and turn the access point to secure it onto
1. Place the plastic bracket on the wall where you want to mount the base
the plastic bracket.
station.
2. Mark the wall where the four outer
mounting holes are.
3. Using the wall anchors and tall
screws, attach the mounting bracket
to the wall.
4. Align the two rectangular holes in
the bottom of the access point with
the protruding hooks on the plastic
Desk Installation
bracket.
For desk installation, attach the four round rubber feet to the locations marked by
the gray circles on the bottom of the access point.
Support
Thank you for purchasing this NETGEAR product. You can visit
www.netgear.com/support
to register your product, get help, access the latest
downloads and user manuals, and join our community. We recommend that you use
only official NETGEAR support resources.
For the current EU Declaration of Conformity, visit
http://support.netgear.com/app/answers/detail/a_id/11621/.
For regulatory compliance information, visit
http://www.netgear.com/about/regulatory/.
See the regulatory compliance document before connecting the power supply.
DRAFT
© NETGEAR, Inc., NETGEAR and the NETGEAR Logo are trademarks of NETGEAR, Inc. Any non-NETGEAR
trademarks are used for reference purposes only.
NETGEAR, Inc.
NETGEAR INTL LTD
350 East Plumeria Drive
Building 3, University Technology Centre
Curraheen Road, Cork, Ireland
San Jose, CA 95134, USA
Advertisement
