Fujitsu DESKPOWER 5000 Series User Manual page 60

IDE Primary Master/Save, IDE Secondary Master/Slave Menu
Using submenus, set the type of hard disk (master or slave) mounted on the primary IDE
connector and secondary IDE connector as well as the size and the number of cylinders).
Move the cursor to a desired item and press the Enter key to display the selected submenu.
Point
- IDE Primary Master: XXXX MB. The Hard Disk cpacity vary depending on model.
F1
ESCExit
– Type
Set the type of IDE device. A value other than [Auto] requests the user to enter
[Cylinders], [Heads], and [Sectors].
- Auto (Initial value)
The computer automatically sets the type of IDE device. Select this item when the
user-skip IDE device is setup.
- None
Select when no IDE device is used.
- Hard Disk
Select for setting details on the hard disk drive.
- CD-ROM
Select when a CD-ROM drive is connected.
- LS-120
Select when a super disk is connected.
- Other ATAPI
Select when any other ATAPI device is connected.
Point
- To change the type, select with the space key.
- Usually, select [Auto]. If any other value is selected, set a correct value supported by the
connected device, otherwise the computer may not access the device correctly.
For details, consult the manual included with the device.
50
PhoenixBIOS Setup Utility
Main Advanced Security
IDE Primary Master [XXXX MB]
Type:
Cylinders:
Heads:
Sectors:
Maximum Capacity:
Multi-Sector Transfers: [16 sector]
LBA Mode Control:
Transfer Mode:
DMA Mode:
↑↓
Help Select Item
←→
Select Menu
Power Boot
[AUTO]
[13328]
[ 15 ]
[ 63 ]
6449 MB
[Enabled]
[Fast PIO 4]
[Ultra DMA2]
-/Space Change Value
Select :Sub-Menu F10Save and Exit
Enter
Info Exit
Item Specific Help
Select ATA/ATAPI
drive installed
here.
[Auto]
The BIOS auto-types
the drive on boot
time.
Except [Auto]
You enter parameters
of the drive.
[None]
The drive is
disabled.
F9 Setup Defaults