Installing A Display Card (Windows 95 Or 98 Model); Replacing The Display - Fujitsu DESKPOWER 5000 Series User Manual

Installing a display card (Windows 95 or 98 model)

When installing a display card in the PCI slot, delete "ATI Display Driver" in advance according
to the procedure shown below.
1
Click [Start]-[Setting]-[Control Panel].
2
Double-click "Add/Remove Programs."
The "Add/Remove Programs Properties" dialog box is displayed.
3
Click "ATI Display Driver."
4
Click "Add/Remove."
The "ATI Uninstall" dialog box is diaplayed.
Click "Yes."
5
Click "Yes"
The PC is restarted.
Start the BIOS Setup.
Select "Display setting" from the Details Menu and change the "Primary dispaly" setting from
"AGP" to "PCI"
Save the change and end the BIOS Setup.
6
Turn off the PC power and install the display card.

Replacing the display

If the display is replaced with a different type of display (especially a liquid crystal dispaly), a
display error such as blank screen may occur. If so, replace the display according to the
following procedure:
Windows 95/98/2000
1
Set the resolution to 640 x 480 (before replacement of the display).
2
Set the refresh rate to the "adapter default."
3
Terminate Windows and turn off the PC power, then replace the display.
If there is no screen display or no display at some resolutoion after the display is replaced
without performing the above setting, reinstall the display driver as follows:
1
Start Windows in Safe Mode.
2
Set the graphic adapter to "Standard Display Adapter (VGA)" or "Standard VGA" and
restart Windows.
3
Reinstall the display driver.
108