Display - Sharp xe-a130 Manual

Display

Your cash register is equipped with a front LED (Light-Emitting Diode) display that affords easy
visibility of 9 digits for the operator during transaction. It also equipped with a rear LED display
which clearly shows the customers a maximum of 7 digits of prices, totals, and change due.
Symbols and figures appearing on the front display:
987654321 987654321
987654321 987654321 987654321
e e e e e
( )
Error: This appears when an error is made and is accompanied by an alarm sound. If this occurs
during a transaction because of an extra digit entry, simply press
p p p p p
( )
Program: This is present when the cash register is being programmed in the "Z/PGM" mode.
f f f f f
( )
Finalization: This appears when a transaction is finalized by pressing
o o o o o
( )
Subtotal: This appears when the cash register computes the subtotal when
also when the amount tendered is less than the total sale amount.
c c c c c
( )
Change: This appears whenever the change due amount is displayed.
C C C C C
( )
Calculation: This appears when you set the mode switch to "CAL" position.
l l l l l
( )
Low battery: This appears when you need to replace the batteries with new ones (see page 26 for
explanation).
In addition, the following appear when appropriate:
•The minus sign (-) can appear in positions 2 to 9.
•The decimal point appears in positions 1 to 3.
Please do the following before using the register for the first time.
Reset the Cash Register
In order for your cash register to operate properly, you must reset it before programming for the
first time. Follow this procedure.
1. Remove the register from its packing carton.
2. Set the mode switch to the REG position.
3. Insert the plug into the AC outlet. Ensure the batteries are not fitted at this point. A
buzzer will sound three times.
4. The register display should now show "l
M
5. Press to confirm the clock starts from "l
6. Now proceed with battery installation as described on page 6.
Departments: Indicates the department entered. For example,
if department 1 was pressed, "1" would appear in the extreme
left position.
Repeat: Indicates the number of times the same department
key is pressed repeatedly. If an entry is repeated more than ten
times, only the first digit is displayed (13 displays as 3).
Before Operation
0.00".
Parts and Their Functions
c
and re-enter correctly.
L G
, or
S
is pressed, and
0-00".
g
.
5