Chapter 9. Pole Display Unit : Up-P16Dp; Chapter 10. Re-232 I/F : Er-A5Rs, Eft & Rs-232 I/F : Er-01Ef - Sharp UP-600 Installation Manual

NOTE: Install the ferrite core in a position less than 50 mm from
the cabinet.
MCR cable
Wire band Wire band
Core
Earth wire
Within 50mm
CHAPTER 9. POLE DISPLAY UNIT :
UP-P16DP
1) Remove the rear cover.
2) Connect the display cable
3) Fix the earth wire to the main chassis
4) Install the core to the display cable
Secure the core with two wire bands.
1
NOTE: Install the ferrite core in a position less than 50 mm from
the cabinet.
MCR cable
Wire band Wire band
Core
Earth wire
Within 50mm
Cabinet
to the POLE connector .
with a screw .
and earth wire .
Cabinet
CHAPTER 10. RS-232 I/F :ER-A5RS ,
EFT & RS-232 I/F:
ER-01EF
1) Connect the extrnal cables to the I/F board.
<ER-A5RS>
•
Install the core (RC0RF6700BHZZ) to the cable with a band.
<ER-01EF>
•
Install the core (RC0RF6700BHZZ) to the cable with a band.
NOTE: Install ferrite core in a position less than 10 mm from the
D-sub connector.
Core
Cable
D-sub connector
Within 10mm
Wire band