Advertisement
Table 1. Programmable Parameters
Parameter
Fahrenheit or Centigrade
Remote Probe Enable
Display Local or Remote
temperature
Set Local Sensor Low Limit
Set Local Sensor High Limit
Set Remote Probe Low Limit
Set Remote Probe High Limit
Select Output Mode (both
relays)
Set Output Map for Output 1
Set Output Map for Output 2
Set Alarm Delay for Output 1
Set Alarm Delay for Output 2
Enable Alarm Audible
Annunciator
Audible Alarm Silence
Timeout
Hysteresis
NOTES:
1
If programmed for Normally Closed (NC) it is supervised, if Normally Open (NO) it is unsupervised.
2
The Output map is a graphical representation of the possible choices.
The left character indicates which relay you are mapping, 1 or 2.
The middle character is the local sensor map and the right character is the remote probe map. See Table 2 for
map designations.
3
Hysteresis provides a buffer so that temperature that is shifting back and forth around the alarm limit point will
not create multiple alarms. You set the # of degrees that the temperature will have to rise above the
temperature low limit set point or drop below the high limit set point for the alarm to turn off. For example, if
you set the HYS at 3 degrees and your low limit is 40 degrees, you will go into an alarm condition when the
temperature reaches 39 degrees and restore from alarm would not occur until the temperature rose to 43
degrees. Hysteresis is limited to ½ the difference in degrees between the low temperature limit and high
temperature limit or the programmed HYS setting (max of 10E) whichever is least.
4
The setup will NOT be lost in the event that power is lost at the panel.
5
Options that relate to the remote probe will only appear is you have enabled the remote probe in selection 2
of the table parameters.
6
High/Low limits shown in table are degrees Fahrenheit. Equivalent Centigrade temperatures apply when
Centigrade has been selected.
7
Hysteresis is always programmed in degrees Fahrenheit, even if Centigrade has been selected to set limits.
Display
1
2
2
3
Degrees of
Default
F-C
F
rEN
NO
DSP
LCL
LLO
40
LHI
I40
RLO
40
RHI
I40
Out
NC
OuI
I
Ou2
2
DLI
0
dL2
0
AUD
YES
SIL
0
HYS
0
-2-
Min
Max
F
C
NO
YES
LCL
RPR
32
I40
32
I40
I40
-40
I40
-40
NC
NO
I
I
2
2
0
255
0
255
NO
YES
0
255
0
I0
Advertisement
