Checking the tyre pressure
The tyre pressure should be 1,0 bar / 100 kPa / 14,5 PSI for
all wheels
IMPORTANT!
Different tyre pressures on the front tyres will result in the
blades cutting the grass at different heights.
Checking the engine's cooling air
intake
WARNING! The cooling air intake rotates
!
when the engine is running. Mind your
fingers.
Clean the air intake grille in the engine cover behind the
driver's seat.
•
Open the engine cover.
•
Check that the cooling intake is free from leaves, grass
and dirt.
Maintenance
•
Check the air duct, located on the inside of the engine
cover, ensure it is clean and does not rub against the
cooling air intake.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
Replacing the cutting belt
Dismantling
The entire cutting unit belt is removed according to the
following when a snow blade is to be attached to the machine.
1 Lower the cutting unit.
2 Remove the front cover.
3 Loosen the automatic belt tensioner stay.
4 Remove the left-hand wing cover.
5 Pull the spring stay from the lifting chain.
6 Unscrew the belt shield.
– 25
English