Verifying Controller Configuration; Performance Monitoring; Configuring Structure-Agnostic Tdm Over Packet - T1 Interfaces - Cisco ASR 900 Series Configuration Manual

Performance Monitoring

cablelength short 110
linecode b8zs
no shutdown
exit

Verifying Controller Configuration

Use show controllers command to verify the controller configuration:
#show controller t1 0/4/0
T1 0/4/0 is up
Applique type is
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear
Framing is unframed, Clock Source is Recovered Clock 0.
BER thresholds:
Data in current interval (0 seconds elapsed):

Performance Monitoring

You can view the statistics or error count generated on the TDM lines for DS1.
The performance monitoring result is displayed using the show controller command for all the modes. The
following snippets display the performance monitoring details when show controller command is executed:
PE2#show controller t1 0/4/0
T1 0/4/0 is up
Applique type is
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear
Framing is unframed, Clock Source is Recovered Clock 0.
BER thresholds:
Data in current interval (0 seconds elapsed):

Configuring Structure-Agnostic TDM over Packet - T1 Interfaces

To configure Structure-Agnostic TDM over Packet (SAToP), use the following commands:
enable
configure terminal
controller t1 0/4/0
cem-group 0 unframed
exit
interface cem 0/4/0
cem 0
xconnect 2.2.2.2 10000 encapsulation mpls
exit
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
16
A900-IMA3G-IMSG
LOS State:Clear
SF = 10e-3
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
0 Near-end path failures, 0 Far-end path failures, 0 SEF/AIS Secs
A900-IMA3G-IMSG
LOS State:Clear
SF = 10e-3
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
0 Near-end path failures, 0 Far-end path failures, 0 SEF/AIS Secs
LOF State:Clear
SD = 10e-6
LOF State:Clear
SD = 10e-6
Configuring T1 Interfaces