Cleaning And Care; Troubleshooting - Electrolux CHC645BA User And Installation Manual

cleaning and care

WARNING
WARNING
Risk of burns from residual heat.
WARNING
WARNING
Sharp objects and abrasive cleaning materials will damage the
appliance. Clean with water and washing up liquid.
WARNING
WARNING
Residues from cleaning agents will damage the appliance.
Remove residues with water and washing up liquid.
Cleaning the appliance after each use
1. Wipe the appliance with a damp cloth and a little washing
up liquid.
2. Rub the appliance dry using a clean cloth.
8 CLEANING AND CARE Ceramic Cooktops
Removing deposits
1. Place a scraper on the glass ceramic surface at an angle.
2. Remove residues by sliding the blade over the surface.
3. Wipe the appliance with a damp cloth and a little washing
up liquid.
4. Rub the appliance dry using a clean cloth.
REMOVE
AFTER
TYPE IMMEDIATELY USE
COOLING
Sugar, food
containing yes – a scraper*
sugar
Plastics,
yes – a scraper*
tin foil
cleaner
for glass
Limescale and
– yes ceramic or
water rings
stainless
steel*
cleaner
for glass
Fat splashes – yes ceramic or
stainless
steel
cleaner
for glass
Shiny metallic
– yes ceramic or
discolouration
stainless
steel
* Scrapers and cleaners for glass and stainless steel can be
purchase in specialist shops.
IMPORTANT
TIPS & INFORMATION
Remove stubborn residues with a cleaner for glass ceramic
or stainless steel.
Scratches or dark stains on the glass ceramic that cannot be
removed do not however affect the functioning of the appliance.

troubleshooting

PROBLEM POSSIBLE CAUSE
The appliance is not connected to
You cannot activate the appliance or
an electrical supply or it is connected
operate it.
incorrectly.
You touched 2 or more sensor fields at the
same time.
There is water or fat stains on the control
panel.
The appliance deactivates.
You put something on the sensor field
The residual heat indicator does not come The cooking zone is not hot because it
on. operated only for a short time.
The cookware is too large or you put it
The sensor fields become hot.
too near to the controls.
comes on. The Automatic Switch Off operates.
and a number come on. There is an error in the appliance.
If you tried the above solutions and cannot re- pair the problem,
speak to your dealer or the customer service. Give the data from
the rating plate, and an error message that comes on.
Make sure, you operated the appliance correctly. If not the
servicing by a customer service technician or dealer will not be
free of charge, also during the warranty period. The instructions
about the customer service and conditions of guarantee are in
the guarantee booklet.
REMEDY
Check if the appliance is correctly
connected to the electrical supply (refer to
connection diagram).
Activate the appliance again and set the
heat setting in less than 10 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the sensor field.
.
If the cooking zone operated sufficiently
long to be hot, speak to the service
centre.
Put large cookware on the rear cooking
zones if necessary.
Deactivate the appliance and activate it
again.
Disconnect the appliance from the
electrical supply for some time. Disconnect
the fuse from the electrical system of the
house. Connect it again. If comes on
again, speak to the service centre.
Ceramic Cooktops TROUBLESHOOTING 9