MSDP-VRF: Example
!
peer 192.168.12.2
connect-source pos 0/2/0/0
!
MSDP-VRF: Example
This is an example where, peer 1.1.1.1 is configured in the VRF context for vrf1.
config
router msdp
vrf vrf1
exit
end
!
•
Configuring Route Policy for Static RPF: Example
router static
address-family ipv4 multicast
202.93.192.74 /32 202.40.148.11
!
route-policy pim-policy
set rpf-topology ipv4 multicast topology default
end-policy
!
router pim
address-family ipv4
rpf topology route-policy pim-policy
Configuring IPv4 Multicast VPN: Example
Cisco XR 12000 Series Routers support only IPv4 addressing.
This end-to-end configuration example shows how to establish a multicast VPN topology
in CE4PE1PE2 CE3MVPN Configuration, on page
BGP) to broadcasting traffic between customer-edge(CE) routers and provider-edge (PE) routers:
Figure 10: Topology in CE4PE1PE2 CE3MVPN Configuration
CE4------------------ PE1 ------------------------------------------------ PE2 ------------------ CE3
For more configuration information, see the
related configuration information in Cisco IOS XR Routing Configuration Guide for the Cisco XR 12000
Series Router .
Cisco IOS XR Multicast Configuration Guide for the Cisco XR12000 Series Router, Release 5.1.x
100
peer 1.1.1.1
Implementing Multicast Routing on Cisco IOS XR Software
100), using two different routing protocols (OSPF or
Configuring Multicast VPN, on page 59
(Figure 10: Topology
of this module and also
OL-30405-02