Uninstalling A Patch Step-By-Step - HP A7500 Series Configuration Manual

Confirming running patches
After you confirm that the installed patch is running, the patch state changes to RUNNING, and the
patch is in the normal running stage. After the device is reset or rebooted, the patch is still valid.
Follow these steps to confirm the running of patches in standalone mode:
To do...
Enter system view
Confirm the running of patches
Follow these steps to confirm the running of patches in IRF mode:
To do...
Enter system view
Confirm the running of patches
NOTE:
This operation is applicable to patches in the ACTIVE state only.

Uninstalling a patch step-by-step

Step-by-step patch uninstallation task list
Task
Stopping running patches
Deleting patches
Stopping running patches
When you stop running a patch, the patch state becomes DEACTIVE, and the system runs the way it did
before it was installed with the patch.
Follow these steps to stop running patches in standalone mode:
To do...
Enter system view
Stop running patches
Follow these steps to stop running patches in IRF mode:
To do...
Enter system view
Stop running patches
Use the command...
system-view
patch run [ patch-number ] [ slot
slot-number ]
Use the command...
system-view
patch run [ patch-number ] [ chassis
chassis-number slot slot-number ]
Remarks
Required
Required
Use the command...
system-view
patch deactive [ patch-number ] slot
slot-number
Use the command...
system-view
patch deactive [ patch-number ] chassis
chassis-number slot slot-number
122
Remarks
—
Required
Remarks
—
Required
Remarks
—
Required
Remarks
—
Required