Base Station Wall Mounting Installation - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100
Lower LED,
red/Green
11.2
System Hardware Manual
LED Status
RED Steady On
RED Flashing
Green Flashing
Off

Base Station Wall Mounting Installation

Ensure the wall can support the weight of the base station.
.
1. Hold the mounting plate in its final location and mark the screw locations
on the plate as shown below.
Figure 5-149 Base Station Dimensions
2. Insert the appropriate anchors for the wall material.
3. Insert the mounting screws into the anchors, leaving about 1/4 inch of
space between the screw head and the wall.
4. Connect the Ethernet cable and route the cord.
5. Place the base over the screw heads and slide it down into place.
State
Power but FPGA starting up
Trying to connect to the network
Network status display and showing network
activity.
AP300 operational
Issue 7.0
Meaning
5 - 121