Cisco Catalyst 3750-E Software Configuration Manual page 159

Chapter 5 Managing Switch Stacks
Beginning in privileged EXEC mode, follow these steps to assign a member number to a stack member.
This procedure is optional.
Command
Step 1 configure terminal
Step 2
switch current-stack-member-number
renumber new-stack-member-number
Step 3
end
Step 4 reload slot stack-member-number
Step 5 show switch
Step 6 copy running-config startup-config
Setting the Stack Member Priority Value
This task is available only from the stack master.
Note
Beginning in privileged EXEC mode, follow these steps to assign a priority value to a stack member:
This procedure is optional.
Command
Step 1
configure terminal
Step 2 switch stack-member-number priority
new-priority-number
Step 3 end
Step 4
reload slot stack-member-number
Step 5 show switch stack-member-number
Step 6 copy running-config startup-config
Provisioning a New Member for a Switch Stack
This task is available only from the stack master.
Note
OL-9775-08
Purpose
Enter global configuration mode.
Specify the current stack member number and the new stack member
number for the stack member. The range is 1 to 9.
You can display the current stack member number by using the show
switch user EXEC command.
Return to privileged EXEC mode.
Reset the stack member.
Verify the stack member number.
Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the stack member number and the new priority for the stack
member. The stack member number range is 1 to 9. The priority value
range is 1 to 15.
You can display the current priority value by using the show switch user
EXEC command.
The new priority value takes effect immediately but does not affect the
current stack master. The new priority value helps determine which stack
member is elected as the new stack master when the current stack master
or switch stack resets.
Return to privileged EXEC mode.
Reset the stack member, and apply this configuration change.
Verify the stack member priority value.
(Optional) Save your entries in the configuration file.
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
Configuring the Switch Stack
5-23