Table of Contents
Advertisement
Additional Information
The use of this equipment may be subject to
local rules and regulations. The following rules
and regulations may be relevant in some or all
areas.
European Notice
Products with the mark comply with the Radio
& Telecommunication Terminal Equipment
Directive (1999/5/EEC), the Electromagnetic
Compatibility Directive (89/336/EEC) and
the Low Voltage Directive (73/23/EEC) - as
amended by Directive 93/68/ECC - issued by
the Commission of the European Community.
Compliance with these directives implies
conformity to the following European
Standards:
• 1999/5/EEC Radio &
Telecommunication Terminal Equipment
Directive (R&TTE) EN 301 511
• Specifi c Absorption Rate (SAR)
Standard: EN 50360, EN 50361
• 73/23/EEC Low Voltage Directive
(LVD) Standard: EN 60950:2000
• 89/336/EEC Electromagnetic
Compatibility (EMC-Directive)
Standard: EN 301489-1/7
• The manufacturer cannot be held
responsible for modifi cations made by
the user and the consequences thereof,
70
which may alter the conformity of the
Appendix
product with the mark.
RF Exposure Information
(SAR)
This model phone meets the government's
requirements for exposure to radio waves.
This phone is designed and manufactured not
to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government.
The exposure standard for wireless mobile
phones employs a unit of measurement known
as the Specifi c Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6W/kg. Tests for
SAR are conducted using standard operating
positions accepted by the FCC with the phone
transmitting at its highest certifi ed power level
in all tested frequency bands. Although the SAR
is determined at the highest certifi ed power
level, the actual SAR level of the phone while
operating can be well below the maximum
value. This is because the phone is designed
to operate at multiple power levels so as to use
only the power required to reach the network. In
general, the closer you are to a wireless base
station antenna, the lower the power output.
The SAR maximum result found during testing
for ASUS J202 are 1.13 w/kg for PCS head
and 0.204w/kg for PCS Body.
Advertisement
Table of Contents
