Breville the Steam Zone Series BFS800 Instruction Book page 11

4. Press the START|PAUSE button and the
zone with the longer steaming time will
start. The second zone will automatically
start so that both zones finish steaming at
the same time.
5. After the steaming time is finished,
the steamer will beep three times. If KEEP
WARM was enabled, the steamer will
automatically enter KEEP WARM mode for
15 minutes. When KEEP WARM is finished,
the steamer will beep one time.
Pause cooking
You can stop/pause steaming in all
steaming modes.
1. During steaming, press the START|PAUSE
button to pause the steaming. The LCD
backlight will change from orange to white.
2. When START is pressed to resume,
RAPID START will flash on LCD for
10 seconds.
Adding water while cooking
You can add water at any time during cooking
by pouring water into the water fill spout.
1. If the water level gets low during steaming,
the steamer will beep twice and FILL
WATER will flash on the LCD screen.
The steamer and timer will pause and the
LCD backlight will change from orange
to white. The steamer will continue to beep
every 30 seconds until the water is refilled.
2. Pour water into water fill spout.
3. Once the water is refilled, the steamer will
automatically restart.
Descaling
DESCALE ME will display on your LCD when
it is time to perform the descale.
NOTE
If the DESCALE ME reminder is ignored, the
unit will prevent any further cooking until a
descale has been performed.
1. Add 1 cup white vinegar and 3 cups
clean tap water to the tank.
2. Place the drip tray, steaming tray and
stainless steel lid onto the steamer base.
3. Turn on the unit by pressing the
POWER button.
4. Press and hold the START button for
5 seconds to activate the descale cycle.
5. The descale cycle will take about
20 minutes; its progress will display
on the LCD.
6. When finished empty the drip tray and
the water tank.
7. Use a damp cloth or paper towel to remove
any remaining scale from the edges of the
steam nozzles.
8. Add 2 cups clean tap water to the tank and
run the steamer on HIGH for 5 minutes to
purge any remaining descaling solution
from the system.
11