Black & Decker FreeWire FWMR Owner's Manual page 9

Freewire Operation, cont.
A Quick Note before You Set Up the TVREMOTE:
WARNING: For indoor use only.
Open door to the TV REMOTE to expose the colored
dial shown in Figure 2 below.
Figure 2
The numbers and colors on the TV REMOTE's dial
match the numbers and colors on the MESSENGER
HUB and LAMP RECEIVERS.
The colors on the dial for the Unit Code can be used to
divide your home into zones with up to 3 dedicated Unit
Codes per color (except red which only has one Unit
Code.) (e.g. Green = Living Room)
The numbers are used to differentiate one receiver from
another in each color/zone.
Reference Label Set Up
For your convenience, a blank reference label is located
on the back of your TV REMOTE. Write your own
customized applications on this label.
Example: Red Unit Codes have been selected for the
BULB RECEIVER in the Entrance
Gray Unit Codes have been selected for the
RECEIVERS in the Dining Room
Green Unit Codes have been selected for the RECEIVER
in the Living Room etc.
16
Freewire Operation, cont.
Step 1:
Set the dial on your TV REMOTE to the same Unit Code
(color) that you selected on the MESSENGER HUB.
Step 2:
Each of the 3 individual codes on that color can be
turned on and off individually, using the 3 white ON/
OFF buttons located just above the dial as shown in
Figure 2 on the previous page.
Example: Blue 11 - Controlled by the top row, left switch
Blue 12 - Controlled by the top row, center switch
Blue 13 - Controlled by the top row, right switch.
The small round ON button and OFF buttons shown in
Figure 3 let you turn on or off ALL Receivers set to
that color.
Figure 3
You should now be able to turn the lamp on and off
with the corresponding button on the TV REMOTE.
Note: You may have to press and momentarily hold the
button before it activates.
17