Code Search - Black & Decker FreeWire FWMR Owner's Manual

Code Entry, cont.
Programming with Code Search
If your product does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.
1. Turn on the device ( ,
TV VCR
2. Press and quickly release the desired mode button
( , , etc.).
TV VCR
3. Press and hold the
SETUP
buttons blink green, then the button you pressed in
step 2 stays on, then release the
4. Press the button repeatedly (up to 300
CHANNEL UP
times) until the device to be controlled changes
channel. The green indicator blinks off with each
button press. If you accidentally overshoot the
code required, press the
to backtrack through the library until the device
changes channel. Pressing
direction to forward again.
5. Press and release to install the code.
MUTE
Most users will store codes under the
VCR
DVD codes under , etc. If (for example) you want to
DVD
store a code under , first follow the procedure
VCR
DVD
for Direct Code Entry (page 10) and press
of Direct Code Entry, then enter ANY VCR code in step 3
of Direct Code Entry. Then follow the steps above for
Code Search (or Brand Search, page 12).
Note: If the device does not have a
button, use ( only) or
VCR
PLAY
Search starts from the currently stored three digit
number under that mode.
2.
3.
10
, etc.) to be controlled.
button until the Mode
button.
SETUP
button
CHANNEL DOWN
changes
CHANNEL UP
button,
VCR
in step 2
DVD
CHANNEL UP
instead. Code
POWER
5.
4.
Code Entry, cont.
Code Search by Brand
Lets you search for a code for a specific Brand within
the Code Library for a particular manufacturer.
1. Turn on the device ( ,
TV VCR
2. Press and quickly release the desired mode button
( , , etc.).
TV VCR
3. Press and hold the
SETUP
buttons blink green, then the button you pressed in
step 2 stays on, then release the
4. Press and release the numeric button (0-9)
corresponding to desired Manufacturer (see table on
next page). The green indicator blinks off once.
Note, pressing "0" performs a full library search same
as normal Code Search Method on previous page.
5. Press the button ((or
CHANNEL UP
( only)) repeatedly until the device to be
VCR
controlled changes channel. The green indicator
blinks off with each button press. If you accidentally
overshoot the code required, press the
button to backtrack through the library until
DOWN
the device changes channel. Pressing
changes direction to forward again.
6. Press and release to install the code.
MUTE
Brand Search Method entry is now complete.
Note: When all codes under a Brand have been searched
the red indicator flashes rapidly for 3 seconds.
2.
3.
4.
11
, etc.) to be controlled.
button until the Mode
button.
SETUP
or
POWER PLAY
CHANNEL
CHANNEL UP
6.
5.