Honeywell UDC3500 Product Manual page 130

Configuration
Function Prompt
Lower Display
114
Selections or
Range of Setting
Upper Display
OUTPUT
SP
LSP 1
RSP
IN ALG1
IN ALG2
PV 2
CBOUTL2
UDC3500 Universal Digital Controller Product Manual
Parameter
Definition
OUTPUT—Represents the displayed controller
output in percent (%).
ATTENTION Also see CB OUT when using a
characterizer on the output value.
ATTENTION When Position Proportional Control is
configured as the Output Algorithm; OUTPUT
represents the actual Slidewire Position whether in
Automatic or Manual Mode. Should the Slidewire
input fail for any reason, the Auxiliary Output will go
to the value configured for FAILSAFE OUTPUT
VALUE in the Control Setup Group.
ATTENTION When Three Position Step Control
(TPSC) is configured as the Control Algorithm;
OUTPUT represents only the estimated motor
position, not the actual motor position.
SETPOINT—Represents the value of the setpoint
currently in use (LSP1, LSP2, LSP3, RSP or CSP)
and is shown in the same units as those used by the
PV.
LOCAL SETPOINT ONE—Output represents Local
Setpoint 1 regardless of active setpoint.
REMOTE SETPOINT—Represents the configured
RSP regardless of the active SetPoint.
INPUT ALGORITHM 1 OUTPUT—Represents the
output from input algorithm 1.
INPUT ALGORITHM 2 OUTPUT—Represents the
output from input algorithm 2.
PROCESS VARIABLE FOR LOOP 2—Represents
the value of the Process Variable for Loop 2.
CONTROL BLOCK OUTPUT FOR LOOP 2—
Output for Loop 2 as calculated by the control block
(such as PID A). When using one of the
characterizers, OUTPUT 2 is the output value for
Loop 2 after it passes through the characterizer. CB
OUTL2 is the control block output before it passes
through the characterizer.
3/07