Setting Programs; Viewing On The Display And Navigating Through The Menu - Bosch FW 200 Installation And Operating Instructions Manual

US/CA
With appliances connected to a domestic hot
•
water tank, the DHW program specifies the
desired water temperature (set temperature).
– If the temperature measured in the
domestic hot water tank is below the
specified temperature, the tank is re-
heated.
– Once the specified temperature is reached
(or exceeded), tank heating is stopped.
If the DHW program changes from a
higher to a lower specified
temperature, the water in the tank
will not immediately cool to the
lower temperature, i.e. water at a
higher temperature will continue to
be available for some time.
However, the tank will not be
reheated until the temperature falls
below the new, lower specified
temperature.
Recirculation program
The recirculation program specifies when a
connected secondary recirculation pump for
domestic hot water runs.
5.2

Setting programs

The functions of the controls and the
meanings of the symbols on the
display are explained on pages 2
and 3.
5.2.1 Viewing on the display and navigating
through the menu
The user interface of the outdoor reset controls
FW 200 is implemented as a menu system. Within
that menu system, the various functions are
arranged in a hierarchical structure. For greater
clarity, the menu system is subdivided into three
sections (MAIN MENU, INFO, and INSTALLER
SETTINGS). Each section can be accessed by its
own button. The entire menu structure is shown
in tabular form in Sections 6.1, 7 and 8.1.
To navigate through the menu system:
menu
Pressing opens the MAIN MENU. From
•
any point within the MAIN MENU, pressing
menu
takes you back to the default display.
Pressing opens the INFO. From any
info
•
point within the INFO menu, pressing
takes you back to the default display.
Pressing and holding
•
seconds opens the INSTALLER SETTINGS
menu. From any point within the INSTALLER
SETTINGS menu, pressing
back to the default display.
The menu option/parameter selected in each
•
case is highlighted
Arrows in the left margin indicate that there is
•
more information than can be shown on the
display at once. It can be viewed by turning
the dial .
Pressing the dial
•
associated with the selected menu option/
parameter or activates editing mode for the
parameter (the parameter setting starts
flashing).
A flashing parameter value (e.g. switch point
•
or operating mode)
– can be changed by turning the dial
– can be reset to the factory settings by
pressing
– is stored by pressing the dial
– remains unchanged if any other button
apart from the dial
To return to the next menu up from a
•
submenu:
– Select the menu option back
confirm by pressing the dial
Press .
–
Operation | 23
menu
for at least 3
menu
takes you
.
opens the submenu
.
is pressed.
,or
6 720 643 256 (2010/05)
info
.
.
and