Installation - Zanussi ZRB38212WA User Manual

Problem
Side panels of the appliance
are warm.
There is too much condensed
water on the rear wall of the
refrigerator.
Door does not open easily.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.

INSTALLATION

WARNING! Refer to Safety chapters.
POSITIONING
This appliance can be installed in a dry, well
ventilated indoor where the ambient temperature
corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
8
Possible cause
The QuickFreeze function is
switched on.
This is a normal state caused
by operation of the heat ex-
changer.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open the
door immediately after clos-
ing.
REPLACING THE LAMP
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service Centre.
ELECTRICAL CONNECTION
The wires in the mains lead are coloured in
accordance with the following code:
Solution
Refer to "QuickFreeze function".
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when the
ambient temperature exceeds
38°C.
Open the door only when neces-
sary.
Make sure the door is closed
completely.
Wrap food in suitable packaging
before storing it in the appliance.
Wait a few seconds between
closing and re-opening of the
door.
CAUTION! Any electrical work
required to install this appliance
should be carried out by a qualified
electrician or competent person.
WARNING! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.