Advertisement
Installation
Please note
If you are discarding an old refrigerator
or freezer that has a lock on the door,
please ensure that the lock is made
unusable to avoid accidents to
young children.
Electricity Supply
The appliance is for operation on a
220/240V 50 c/s supply, so be sure that
your electricity supply voltage is
within the range which is marked on
the nameplate located inside the cabinet
Earthing
WARNING
TfflS APPLIANCE MUST BE
EARTHED. The manufacturer declines
any liability should this safety
measure not be observed.
Electrical Connection
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
GREEN AND YELLOW - EARTH
BLUE-NEUTRAL
BROWN - LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
ar plug, thi^ is what you have to do:
Connect the green and yellow (earth)
wire to the terminal in the plug which is
marked with the letter "E" or the earth
symbol i , or coloured green, or green
and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked
with the letter "N" or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
"L" or coloured red.
«If plug is not suitable it must be cut
off and appropriate plug fitted».
The plug moulded on to the cord
incorporates a fuse. For replacement, use
a 13 Amp BS 1362 fuse. Only ASTA
approved fuses should be used.
The fuse cover/carrier must be replaced
in the event of changing fuse.
The plug must not be used if the fuse
cover/camer is lost
A replacement cover/carrier must be
obtained from Zanussi Service Agents
whose addresses are listed on the
attached ''Zanussi Service Agents
Nationwide".
THIS APPLIANCE COMPLIES WITH
E.E.C. DIRECTIVE NO. 76/889
OF 4.11.76 RELATIVE TO RADIO
INTERFERENCE SUPPRESSION.
Location and levelling
Place the appliance away from heat
sources and in such a way that air can
circulate freely at the back of the
cabinet. Level by adjusting the special
levelling feet on the bottom of
the cabinet
Before using
Remove all securing tapes. Wash inside
the appliance with lukewarm water
and a little bicarbonate of soda (one
teaspoonful to a quart of water). Do not
use soap or detergents as the smell
might linger. Dry thoroughly. Repeat the
above for regular cleaning of your
appliance.
Advertisement
