Makita 6704D Instruction Manual page 6

Reversing switch action
1
A
B
004160
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
This tool has a reversing switch to change the direction of
rotation. Slide the reversing switch to the A side (appear
"F" marking) for clockwise rotation or to the B side
(appear "R" marking) for counterclockwise rotation.
Overload protector
For 6704D
The overload protector automatically cuts out to break
the circuit whenever heavy work is prolonged. Wait 20-30
seconds before resuming operation.
Adjusting the fastening torque
1
3
004162
The fastening torque can be adjusted infinitely from
approx. 20 Kg•cm to 80 Kg•cm. To adjust it, loosen the
two screws and turn the adjusting ring. Then tighten the
screws to secure the adjusting ring. Refer to the table
below for relation between the numbers on the adjusting
ring and the fastening torque to be obtained.
Number on adjusting ring
1
2
3
4
5
006402
Example
35 Kg• cm of fastening torque can be obtained when the
number 2 is aligned to the red mark.
1. Reversing switch
1. Red mark
2
2. Screw
3. Number
4. Adjusting ring
4
Fastening torque to be obtained
20 Kg cm
35 Kg cm
48 Kg cm
60 Kg cm
80 Kg cm
NOTE:
Always tighten the two screws to secure the
•
adjusting ring after adjusting the fastening torque.
The fastening torque may differ depending upon
•
the kind of screws, the type of materials to be
fastened, etc. Before starting your job, always
perform a test operation to verify the adequate
fastening torque.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing socket
For tool with square drive
Use 9.5 mm square drive socket with a hole for detent pin
which is available on the market ( Note: Use 6.35 mm
square drive socket when using the tool with 6.35 mm
drive.)
1
004168
To install the socket, depress the detent pin on the
square drive with your finger and push the socket onto
the square drive until the detent pin is inserted into the
hole in the socket.
1
004169
To remove the socket, depress the detent pin with a small
hand tool and pull off the socket.
6
1. Hole for detent
9.5 mm
pin
or
6.35 mm
1. Detent pin
2. Square drive
2