Brake Light Switch; Indicator Lamp Replacement; Headlamp Switch - Polaris A09BG50AA User Manual

BRAKE LIGHT SWITCH

1. Disconnect wire harness from switch. Located on
bulk head under front cover.
2. Connect an ohmmeter across switch contacts.
Reading should be infinite (∞).
3. Apply brake at handlebar lever and check for
continuity between switch contacts.
switch if there is no continuity or greater than .5
ohms resistance when the brake is applied with
slight pressure.

HEADLAMP SWITCH

Head lamp connector
BRN
GRN
YEL
Probe the high beam Head lamp plug wires (Brown
and Yellow) at back of connector. Turn headlight
switch on. Test for battery voltage across the
connections.
NEUTRAL LIGHT CIRCUIT
OPERATION
Power is supplied to the transmission switch from the
Red/White wire when the key is on. When neutral is
selected, power flows through the switch to the
Green/White wire, through the lamp and to ground via
the Brown wire.
If the light is not on when neutral is selected, check the
bulb. If the bulb is good, check the wiring,
transmission switch, and lamp socket ground path.
INDICATOR LAMP
REPLACEMENT
1. Remove retaining nuts holding choke and key
switch.
2. Disconnect indicator light panel from harness.
Replace
Rear view of indicator lamp panel
3. To remove defective light: Use a small
screwdriver and turn light holder a quarter turn
clockwise. Pull light holder out with a needle nose
pliers or equivalent. Replace with new holder and
bulb assembly. Reassemble panel.
ELECTRICAL
1/4 Turn
10.31