Spanning Tree And Switch Stacks - Cisco 3032 Software Configuration Manual

Configuring Spanning-Tree Features
VLAN spanning trees to prevent loops from forming if there are multiple connections among VLANs.
It also prevents the individual spanning trees from the VLANs being bridged from collapsing into a
single spanning tree.
To support VLAN-bridge spanning tree, some of the spanning-tree timers are increased. To use the
fallback bridging feature, you must have the IP services feature set enabled on your switch. For more
information, see

Spanning Tree and Switch Stacks

These statements are true when the switch stack is operating in PVST+ or rapid-PVST+ mode:
•
•
•
•
•
•
•
For more information about switch stacks, see
Configuring Spanning-Tree Features
These sections contain this configuration information:
•
•
•
•
•
•
•
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
18-12
Chapter 46, "Configuring Fallback Bridging."
A switch stack appears as a single spanning-tree node to the rest of the network, and all stack
members use the same bridge ID for a given spanning tree. The bridge ID is derived from the MAC
address of the stack master.
When a new switch joins the stack, it sets its bridge ID to the stack-master bridge ID. If the newly
added switch has the lowest ID and if the root path cost is the same among all stack members, the
newly added switch becomes the stack root.
When a stack member leaves the stack, spanning-tree reconvergence occurs within the stack (and
possibly outside the stack). The remaining stack member with the lowest stack port ID becomes the
stack root.
If the stack master fails or leaves the stack, the stack members elect a new stack master, and all stack
members change their bridge IDs of the spanning trees to the new master bridge ID.
If the switch stack is the spanning-tree root and the stack master fails or leaves the stack, the stack
members elect a new stack master, and a spanning-tree reconvergence occurs.
If a neighboring switch external to the switch stack fails or is powered down, normal spanning-tree
processing occurs. Spanning-tree reconvergence might occur as a result of losing a switch in the
active topology.
If a new switch external to the switch stack is added to the network, normal spanning-tree processing
occurs. Spanning-tree reconvergence might occur as a result of adding a switch in the network.
Default Spanning-Tree Configuration, page 18-13
Spanning-Tree Configuration Guidelines, page 18-13
Changing the Spanning-Tree Mode., page 18-15
Disabling Spanning Tree, page 18-16
Configuring the Root Switch, page 18-16
Configuring a Secondary Root Switch, page 18-18
Configuring Port Priority, page 18-18
Configuring Path Cost, page 18-20
Chapter 5, "Managing Switch Stacks."
(required)
(optional)
(optional)
(optional)
(optional)
(optional)
Chapter 18 Configuring STP
OL-12247-04