Configuring The Http Server - Cisco Catalyst 2960 series Configuration Manual

Command or Action
Step 6
radius-server dead-criteria tries num-tries
Example:
Switch(config)# radius-server dead-criteria
tries 30
Step 7
end
Example:
Switch(config)# end

Configuring the HTTP Server

To use web-based authentication, you must enable the HTTP server within the Switch. You can enable the
server for either HTTP or HTTPS.
Note The Apple psuedo-browser will not open if you configure only the ip http secure-server command. You
should also configure the ip http server command.
Follow these steps to enable the server for either HTTP or HTTPS:
SUMMARY STEPS
1. enable
2. configure terminal
3. ip http server
4. ip http secure-server
5. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch> enable
Purpose
Specifies the number of unanswered sent messages to a RADIUS
server before considering the server to be inactive. The range of
num-tries is 1 to 100.
Returns to privileged EXEC mode.
Purpose
Enables privileged EXEC mode. Enter your password if prompted.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
How to Configure Web-Based Authentication
1437