Installation Procedure
NOTE:
Although model with the Upright Control Panel is used for illustration in this
procedure, the same procedure is applied to model with the Flat Control Panel.
■ Removing the Main Controller PCB 1
1) Press [A] part, and open the Right Rear Cover 1.
[A]
9
Installation > Installation Procedure for Expansion Bus-F1/F2, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Removing
2) Remove the Side Cover.
• 1 Screw (The removed screw will be used in step 7).)
• 2 hocks
3) Disconnect the USB Cable and the Control Panel Cable.
4) Hold the handle and remove the Main Controller PCB 1 while holding the cables.
F-9-228
9
Installation > Installation Procedure for Expansion Bus-F1/F2, IPSec Board-B2 and Wireless LAN Board-B1 > Installation Procedure > Removing
Hook
Hook
x2
Control Panel Cable
USB Cable
Main Controller PCB 1
Handle
9-98
F-9-229
F-9-230
9-98