Replacing The Front Panel (Hdcu1500); Removing The Rear Panel (Hdcu1500) - Sony HDCU1000 Maintenance Manual

2-2-3. Replacing the Front Panel
(HDCU1500)
1. Remove the cover. (Refer to Section 2-2-1.)
2. Loosen the two coin screws.
3. Remove the step shaft and remove the front panel,
nylon washer from the income panel as shown in the
figure below.
Front panel
Step shaft
Front panel
4. Install the front panel in the reverse order.
2-10 (E)
Nylon washer
Income panel

2-2-4. Removing the Rear Panel (HDCU1500)

1. Remove the cover. (Refer to Section 2-2-1.)
2. Disconnect the harness from the connector CN104 on
the SDP-12 board.
3. Disconnect the harness from the power supply unit.
4. Remove the eight screws and the rear panel.
Connector
Rear panel
SDP-12 board
Harness
CN104
Screws
(B3 x 5)
MM/HDCU1000 Series