9. Remove the four nylon rivets, and remove the harness
guide in the direction of the arrow.
10. Disconnect the harnesses from the connectors CN31
and CN32 on the MB-1071 board.
MB-1071 board
CN31
Three clamps
CN32
11. Remove the eight screws and remove the MB-1071
board.
MB-1071
board
12. Install the MB-1071 board in the reverse order.
MM/HDCU1000 Series
Four nylon
rivets
Pull the harness guide in
the direction of the arrow.
Screws
(PSW3 x 6)
2-1-7. Replacing the CNB-21 Board
(HDCU1000/1080)
1. Remove the VIF-34 board and ADO-10 board.
(Refer to Section 2-1-6.)
2. Remove the three screws and remove the rear board
fixing plate.
3. Remove the ten hexagonal screws and remove the
CNB-21 board.
CNB-21 board
Hexagonal screws
4. Install the CNB-21 board in the reverse order.
Screws
(B3 x 5)
Rear board
fixing plate
2-7 (E)