Adjusting Table Alignment - Grizzly G0832 Owner's Manual

3. Rotate cutterhead elevation crank ¼ turn
clockwise to raise cutterhead approximately
⁄ ". This will set depth of cut to
1
64
workpiece from planer.
4. Turn planer ON.
5.
Feed workpiece into front of planer, making
sure not to stand directly in front of or behind
workpiece to reduce the risk of a kickback
injury.
— If cut is too deep and bogs down planer,
turn planer OFF immediately and allow it to
stop. Raise cutterhead, remove workpiece,
reduce depth of cut, then repeat Step 5.
Note: Infeed and outfeed rollers will automat-
ically pull workpiece through planer during
operation. Do not push or pull on workpiece
once feed rollers have engaged it.
6.
Once workpiece is clear of outfeed roller,
measure workpiece thickness. If further plan-
ing is needed, lower cutterhead another
turn ( ⁄ ") of the elevation crank handle, and
1
32
repeat cutting operation.
7.
Continue the process described above until
desired workpiece thickness is reached.
Elevation scale shows approximate thick-
ness of workpiece after it has been cut.
Use this indicator to judge when thickness
is approximately correct. For more precise
applications, measure workpiece thickness
with calipers during cutting operation.
Adjusting Table
Alignment
The front and rear table heights are adjustable for
proper workpiece contact throughout the cut.
Tools Needed
Open-End Wrench 10mm .................................. 2
Precision Straightedge 24" ................................ 1
-24-
To adjust extension table height:
⁄ ". Remove 1.
1
32
2.
⁄
1
2
Figure 20. Location of components for adjusting
3.
4.
Qty
To check alignment, lay a straightedge across
bed and both wings (see Figure 19).
Figure 19. Aligning extension wings.
Loosen stop nuts and adjustment bolts under-
neath each extension wing (see Figure 20).
Adjustment Bolt
Stop Nut
table.
Rotate adjustment bolts so wings and table
are on the same plane.
Note: No gap should be visible beneath
straightedge when tables are properly
aligned.
Use one wrench to prevent adjustment bolt
from rotating while using other wrench to
tighten. Recheck table height from side to
side, then tighten stop nut to secure the set-
ting.
Model G0832 (Mfd. Since 04/17)
Straightedge