Snmp Mib Rep Trap-Rate - Cisco Catalyst 3750 Metro Command Reference Manual

Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands

snmp mib rep trap-rate

Use the snmp mib rep trap-rate global configuration command to configure the sending of Resilient
Ethernet Protocol (REP) SNMP traps when there is a link operational status or port role change. Use the
no version of the command to disable sending of the REP trap.
Syntax Description
trap-rate value
Defaults
Sending REP traps is disabled.
Command Modes Global configuration
Command History Release
12.2(40)SE
Usage Guidelines
Use this command to enable the switch to send REP specific traps corresponding to link operational
status changes and port role changes.
Examples
This example configures the switch to send REP traps at a rate of 10 per second:
Switch(config)# snmp mib rep trap-rate 10
Related Commands Command
show running config
OL-9645-10
snmp mib rep trap-rate value
no snmp mib rep trap-rate
Set the number of REP traps sent per second. The range is from 0 to 1000. The
default is 0 (no limit imposed; a trap is sent at every occurrence).
Modification
This command was introduced.
Description
Verifies that REP traps are configured.
Catalyst 3750 Metro Switch Command Reference
snmp mib rep trap-rate
2-629