Cisco Catalyst 3750 Metro Command Reference Manual page 600

show mpls l2transport vc
local label: 17, remote label: 17, tunnel label: implc-null
outgoing interface: Gi1/1/1, next hop: 10.2.0.2
Local MTU: 1500, Remote MTU: 1500
Remote interface description: FastEthernet1/0/2
Packet totals(in/out): 606955/0
byte totals(in/out): 47342490/0
Table 2-28
Table 2-28
Field
vcid
type
local groupid
remote groupid
vc is up
or
vc is down
client
destination
Peer LDP Ident
local label
remote label
tunnel label
Outgoing interface
Next hop
Local MTU
Remote MTU
Catalyst 3750 Metro Switch Command Reference
2-572
describes the fields in the display.
show mpls l2 transport vc detail Field Descriptions
Description
The virtual circuit identifier assigned to one of the interfaces on the
device.
The forwarding mode used.
The ID used to group VCs locally. EoMPLS groups VCs by the
hardware port, which is unique for each port on a device.
The ID used by the peer to group several VCs.
The state of the VC (up or down):
Up—The VC can carry traffic between the two VC end points. A VC
is up when both the local and remote interfaces are programmed.
The local interface is programmed if the VC is configured and the
•
client interface is up.
The remote interface is programmed if the remote interface is
•
configured and there is a VC remote VC label and an IGP label.
The IGP label means that there is a label-switched path (LSP) to
the peer.
Down—The VC is not ready to carry traffic between the two VC end
points.
The ingress or egress interface through which the Layer 2 VLAN
packet travels. The interface is a VLAN or physical interface.
The destination specified for this VC. You specify the destination IP
address as part of the mpls l2transport route interface configuration
command.
The LDP IP address of the targeted peer.
The VC label that a device signals to its peer device. The local VC label
determines the egress interface of a packet arriving from the MPLS
backbone.
The VC label of the remote peer device.
An IGP label used to route the packet over the MPLS backbone to the
destination device with the egress interface.
The egress interface of the VC.
The IP address of the next hop.
The maximum transmission unit specified for the client interface.
The maximum transmission unit specified for the remote device client
interface.
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
OL-9645-10